mandatory
mandatory

Author Topic: Sam4s ER-430m  (Read 16454 times)

Offline Lindsay McPhee

  • Administrator
  • *****
  • Posts: 165
  • Karma: +2/-0
  • Gender: Male
  • 2B OR NOT 2B = FF
    • Skype - lindsaymcp
    • Goodson Imports
Re: Sam4s ER-430m
« Reply #2 on: January 16, 2019, 09:23:30 AM »
Hi Lee,

Please check your cash register's serial port configuration:

Turn Key to Service mode
     needs key with letter 'C' embossed into it
     Service mode is down at 6 O'clock past P Mode

By Default, port 1 is setup for PC comms - but it may have been changed.

To Set port 1 to work with the computer - make sure the Key is in S Mode.
Type :
[
    8 0 Subtotal
    1 X/Time 0 Cash
    2 X/Time 0 Cash
    3 X/Time 0 Cash
    4 X/Time 0 Cash
    5 X/Time 1 Cash  Cash
 ]

Plug your cable into serial port 1 of the cash register and try again.
The key can be in any mode, but you must not have an active transaction running, or you will get a Register not Ready error again.

If your register does NOT go into online mode after doing the above steps, you may have a cable that is internally not wired correctly.

If your register goes into online mode, but you still get a register not ready after doing the above steps, you may have a broken wire inside your cable.
« Last Edit: January 16, 2019, 09:30:20 AM by Lindsay McPhee »
regards,

Lindsay McPhee
Technical Support, Training and Product Development
Goodson Imports Pty Ltd

Lee Beasley

  • Guest
Sam4s ER-430m
« Reply #1 on: January 15, 2019, 08:57:59 PM »
Hi i have a ER-430M im trying to connect it to my windows 10 PC Via Serial 1 or 2 and have downloaded the Software VIA the Fourms here and followed the instructions but i get stuck after the software opens as when i click "UpProgram ECR ->PC and select All Program as in the instructions i get a error message "REGISTER NOT READY" ive tried Serial 1 and 2 all programed the same as in the instructions but im at a loss Please Help

 

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name: Email:
Verification:
Are you a spam bot?:
Enter 1234:

anything